Pulmochart Reference
Specification of regions of interest in the Start app.

1. Specify regions of interest (optional) in the raw file

Overview

Either the whole raw file can be processed or only specific regions of interest.

Details

On this screen all signals of the raw file can be reviewed in the Original source file monitor. In this signal reviewer regions of interest can be specified.


Original source file monitor:

The signals to be reviewed can be chosen by clicking the Hide signals button. The signals in the reviewer can be scrolled by dragging the scroll bar at the bottom or the yellow Center Cursor in the reviewer to the left or right.
Additionally the signals can be scaled and zoomed by clicking the respective buttons below this reviewer.
1. button: automatic adaption of all signal offsets (shifting up and down)
2. button: automatic scaling of all signals (adaptation of the shown signal ranges according to the value ranges of the signals) If a signal is indicated in the reviewer and it is not visible, this might be due to an inappropriate value range.
3. button: zoom out
4. button: zoom in
Scaling can be also done with a right click on the channel name of a signal. Then a small menu opens for scaling the according signal.

Hide signals:

This button directs to another screen Check all signals that should be visible in the main viewer:. The signal selection is done by checking/unchecking the boxes of the corresponding channels. After the selection the button Ready directs back to the selection of regions of interest.



Select regions of interest:

A region of interest can be selected by dragging a Begin (green) and an End (orange) marker onto the signals from the bottom center panel. The placed markers can be shifted or deleted, if they are not at the desired position. Markers show red boxes which arise by hovering above them. These red boxes can be moved to shift the marker and clicking on the red box deletes the marker. The selected region is indicated in the panel Regions of interest with the start- and the end time. Further regions of interest can be selected in the same way.

Regions of interest (panel):

This panal indicates the selected regions of interest in terms of the start- and the end time point. Each of these time points can be reviewed in the Original source file monitor by clicking on it.

Back:

This button directs back to the selection of a raw file ("Start App").

Next >>:

If everything is adapted, this button directs to the signal specification ("2. Specify the signals in your file that correspond to known signals").